Configure Bluetooth settings on a network printer
The following table describes the Bluetooth settings you can configure on the
tab of the printer's
embedded Web server (EWS)
if the printer is connected
to the network either wirelessly or with an Ethernet cable:
If your printer is not connected to a network, connect a USB cable from
your computer to the rear USB port on the printer and open the printer
to configure the Bluetooth settings.
The hardware address of the Bluetooth device.
You cannot change this address.
The device name assigned to the printer which can identify
it on a Bluetooth device.
A 4-digit value that the user must enter in order to print using
Bluetooth. The default passkey is 0000.
Shows whether or not the printer is visible to other Bluetooth
devices that are within range.
Visible to all
: Any Bluetooth device within range can
print to the printer.
: Only Bluetooth devices that have stored
the device address of the printer can print to it.
The level of security set for the printer connected by
: The printer requires a passkey from the
Bluetooth device before allowing the device to send a
print job to it.
: The printer does not require a passkey. Any
Bluetooth device within range can print to it.
If the optional
250-Sheet Plain Paper Tray
is not installed, the Tray Select options will not
: Selects the upper tray as the paper
: Selects the lower tray as the paper
Resets Bluetooth to factory default settings.
Yes, reset Bluetooth
: Resets Bluetooth to factory
: Settings remain as they are.